Sample report #1

Construction supervision inspection & report. This makeup of this type of report is reliant on the project you are carrying out on your property. Type of work, size, number of different trades involved etc. will influence the overall price and the supervision package we can offer you. Some of the standard checks will be:

• Liaise with yourself & contractors to have our inspector call at a crux point during the works on site.
  (for instance: During a 'new build extension' we would ideally call at the end of the structural, block, brick and framework portion of the works prior to the second fix)
• Record all situated works and materials.
• Photograph work and check levels and measurements.
• Check the ground and existing building 'disturbances'
• Check actual work against 'quoted' works for any major discrepancies
• Written report sent by email after inspection outlining inspection point findings.

Other checks by request:

• At any further points in the project extra inspections can be performed until completion where a snag list can be done.
• Health and Safety points can be noted and advice given. Offering you protection against liability, 'public' injury and unforeseen costs and delays.
• Heavy lift advice and checks for compliance.
• Building energy rating advice for compliance and future cost savings.

Sample report #2

For the purpose of an inspection of a property for a landlord or other party where a complete inspection is required / or for a dilapidation report the price would be based on the square meter of the property.
The areas of the property inspected will normally include...

• Roof Coverings and Construction
• Chimneys, Pots, Flaunchings and Flashings
• Soffits and Fascias
• Gutters and Downpipes
• External and Internal Walls
• Windows, Doors and Ironmongery
• Floors and Floor Finishes
• Ceilings
• Stairs
• Joinery (skirts &trim)
• Insulation and Ventilation
• Heating system– Boilers, radiators, thermostats, flues, fireplaces etc.
• Plumbing – Tanks, cylinders, pipework, lagging, waste water fixtures, fittings etc.
• Electrical – Sockets, switches, cabling, fuse board, fittings, earthing.
• External elements – surfaces, drainage, gullies

Sample Report #3

For the purpose of an inspection & report on a substandard installation or repair This is dependent on the type of work that has been carried out and the stage the work has been left at.

• Collate all information on the work that was quoted for – i.e. Builders or trades persons estimate, quote or schedule of works.
• Inspection of work carried out from structure to finish – Workmanship, materials used, measurement of dimensions quality of installation etc.
• Photographic record of all defects attached to itemized list in inspectors report.
• Discrepancies between work quoted for and work actually carried out noted.
• Advise on remedial repair or reinstatement works as required.

Sample Report #4

For the purpose of a damage report on a residential property This is dependent on the area damaged and cause.

• Determine the cause of damage and record all evidence for proof of said.
• Record all damaged areas and include extent of same in report.
• Photographic record of all damage attached to itemized list in inspectors report.
• Conclusions of inspection process and evidential analysis given in report on consequential damage.
• Advise on remedial repair or full reinstatement works were required.
• Approximate budget for work

Go to the price page and enter the details of the type of inspection and report you require:
Click For a report price / inspection rate